3000GT/Stealth International Message Center - View Single Post - Output shaft replacement without tranny pull: EASY

cbatters · 07-25-2006, 05:39 AM

Haven't replaced it yet.

We tossed in the new xfer case but did not have time to swap the output shaft. (We were helping another member do a 60K and I had to replace a ball joint / tie rod end.)

On the list of things to do this summer while the weather is pleasant.

Clint

07-25-2006, 05:39 AM	#32 (permalink)
cbatters Member: Burned valve club Join Date: Jun 2002 Location: Stoughton, MA Drives: 91 Stealth RT/TT Trader Rating: (12)	Re: Output shaft replacement without tranny pull: EASY Haven't replaced it yet. We tossed in the new xfer case but did not have time to swap the output shaft. (We were helping another member do a 60K and I had to replace a ball joint / tie rod end.) On the list of things to do this summer while the weather is pleasant. Clint __________________ 1991 Stealth RT/TT - Firestorm Red - 193K Miles / Original Owner Maint: Castrol 10W40 / Mitsu Filter / Rislone Replaced: 2X clutch / 3X brakes / 2X front rotors / 2X ABS HU / 1X NGK Plugs / 1X Ball joints / 2X Antenna mast / 1X Active exhaust cable / 1X Windshield / 1X Fuel FIlter / 1X Struts / 1X rear rotors / 1X Front Head / VSS / 1X rear wheel bearings / 1X Transfer case (warranty) / 1x Tie rod end (drivers side) Overhauled: Starter, IAC, BISS, CV Boots Upgrade: SilverStar Headlights / ebay "Xenon" Fog Bulbs (no more yellow!) A/F Gauge / MAP - Electronic Boost Logging / MMCd Data Logger Pending Projects: Steering Rack