Re: ---===The Official MAFT-Pro Thread===---
This is a feature that was added for the Supras, they were doing the documentation.......supposedly.
Anyway, connect the yellow wire to pin 11 (power transistor A)
The resistor you need to disconnect is shown in the attached pic
The F In Mode is set per the documentation, and the timing monitor will work. There are some settings to make it match your timing light or logger in the settings page.
Bob
__________________
Need a datalogger? Check out the Scanmaster 3
PM me about ECU mods for 8000+ RPM rev limits !!!!!!!!
Stock = 7300 RPM
Stage 1 = 8060 RPM
Stage 2 = 8200 RPM
Stage 3 = 8400 RPM
Stage 4 = 8800 RPM (By request only)
1991 Stealth RT/TT, Grooms Shortblock, 13G's. <-- Gone but not forgotten
|