3000GT/Stealth International Message Center - View Single Post

DoctorDex · 07-15-2006, 09:57 AM

Maybe I should have rephrased my question a bit better. Here it goes:

If I have my wideband plugged into the 3.5mm external analog signal stereo jack, does the Scanmaster output it to MMCd via the unused "EGRT output"? What I'm worried about is that if I get everything wired up, only to realize that the Scanmaster is pushing out two signals on one channel, so to speak.

Edit: After reading the scanmaster manual, I have come to realize that this will not be a problem so long as "data substitution" is used.

As far as hooking up the Blitz DSBC map sensor to the EGRT input is concerned, has anybody done this and does anybody know what kind of map sensor is used in the Blitz DSBC?

07-15-2006, 09:57 AM	#117 (permalink)
DoctorDex Forum Member Join Date: Jul 2005 Location: Edmonton, AB Drives: '91 VR4 - RIP Trader Rating: (17)	Re: 1G Electronic Boost Data Logging Maybe I should have rephrased my question a bit better. Here it goes: If I have my wideband plugged into the 3.5mm external analog signal stereo jack, does the Scanmaster output it to MMCd via the unused "EGRT output"? What I'm worried about is that if I get everything wired up, only to realize that the Scanmaster is pushing out two signals on one channel, so to speak. Edit: After reading the scanmaster manual, I have come to realize that this will not be a problem so long as "data substitution" is used. As far as hooking up the Blitz DSBC map sensor to the EGRT input is concerned, has anybody done this and does anybody know what kind of map sensor is used in the Blitz DSBC? __________________ '91 VR4 - Rebuild in progress: Mods TBA.