Re: 1G Electronic Boost Data Logging
Quote:
|
Originally Posted by DoctorDex
Some noob type questions for you guys:
1. I currently run my LC-1 wideband into the scanmaster by means of a 3.5mm stereo jack. Does this mean I am already using the EGRT input or can I go ahead and connect a MAP sensor to the extra EGRT input?
2. I have a Blitz DSBC. Is there a way to tap into the electronic boost gauge of boost controller and wire it into the EGRT?
Thanks.
Declan
|
Kindly take the time to carefully read page 1 of this thread which describes hooking up devices to EGRT input.
__________________
1991 Stealth RT/TT - Firestorm Red - 193K Miles / Original Owner
Maint: Castrol 10W40 / Mitsu Filter / Rislone
Replaced: 2X clutch / 3X brakes / 2X front rotors / 2X ABS HU / 1X NGK Plugs / 1X Ball joints / 2X Antenna mast / 1X Active exhaust cable / 1X Windshield / 1X Fuel FIlter / 1X Struts / 1X rear rotors / 1X Front Head / VSS / 1X rear wheel bearings / 1X Transfer case (warranty) / 1x Tie rod end (drivers side)
Overhauled: Starter, IAC, BISS, CV Boots
Upgrade: SilverStar Headlights / ebay "Xenon" Fog Bulbs (no more yellow!)
A/F Gauge / MAP - Electronic Boost Logging / MMCd Data Logger
Pending Projects: Steering Rack
|