Quote:
|
Originally Posted by Highboosted
I was using the non r/t tunerpro to check out the VE maps and got an idea:
Hey Bob, I was wondering if there's a way to change the VE table scaling so instead of the table going to ~45 psi, to make it go to say 25 psi and have "finer" resolution (instead of 20 kpa between cells, say 10-15 kpa). Would that be a waste of time?
I'm not planning on going to 40 psi just yet.
[edit]: forgot I was looking at absolute numbers, not gauge pressures. question still stands, though.
|
Possible, but not this week........
I am out of town til the 17th.
I will look at it then, it should not be a difficult change. How much boost you planning on running?
B