This is a really quick and easy solution for all of us who need to add on a fuel pressure gauge.
This is a quality little piece, construction is second to none. Mine came with the black face 100psi autometer gauge.
Bob was kind enough to have assembled the adapter, fitting, and gauge already complete with sealant
its hard to tell in this picture but the fitting has been trimmed on the inside so as not to impede flow I believe
Here you can see the adapter fitted to the fuel rail. It came with an o-ring to seal to the rail as well as longer bolts and some lock washers so that you have everything you need. You will also note my AEM fpr mounted via the RobBeck adapter
Here is the complete assembly: rails, injectors, gauge, and fpr. Installing this all was way easier than it should have been given that I am reassembling the entire engine.
Here are two photos of the plenum back in place showing how nicely everything comes together
Bob's fuel pressure gauge adapter coupled with Rob's FPR adapter make for one slick little budget minded fuel system that really looks great and fits well. Both pieces were fabulous, but the focus of this "write up" is e2kmfg's gauge/adapter combo which makes it a snap to "get yo measurements on".
Even with everything assembled this install would only have taken a few minutes to complete.
I did not have to clearance one thing with a file during this whole install, and everything looks like it belongs
Sincerely,
-deathsled