Quote:
|
Originally Posted by VR4swoosh
TurboTension or others,
So what ever happened with your end links hitting? Did you figure out a solution. I just installed both front and rear Saner bars and have no issues so far with my ACPT driveshaft rubbing, but my axle nuts are hitting the linkage when I make a medium-hard turn. I tried taking the spacers out and replacing them with washers and that wasn't enough. I also put the bolts the other way with just the nut on the side of the axle and it still hits on one side. Next I plan to go to pick up some new low profile head grade 8 bolts to try. At last resort, I will try to use the stock end links with the Saner bar. Any other ideas?
|
On the cv flange bolts (if that is what is hitting) you can install the bolts the opposite way so the head side is out instead of the extended bolt