3000GT/Stealth International Message Center - View Single Post

VR4swoosh · 06-14-2006, 01:34 PM

TurboTension or others,

So what ever happened with your end links hitting? Did you figure out a solution. I just installed both front and rear Saner bars and have no issues so far with my ACPT driveshaft rubbing, but my axle nuts are hitting the linkage when I make a medium-hard turn. I tried taking the spacers out and replacing them with washers and that wasn't enough. I also put the bolts the other way with just the nut on the side of the axle and it still hits on one side. Next I plan to go to pick up some new low profile head grade 8 bolts to try. At last resort, I will try to use the stock end links with the Saner bar. Any other ideas?

06-14-2006, 01:34 PM	#23 (permalink)
VR4swoosh Forum Member Join Date: Jan 2001 Location: Seattle, WA Drives: 1993 VR4 Trader Rating: (6)	Re: Review: SANER awd sway bars from 3SX TurboTension or others, So what ever happened with your end links hitting? Did you figure out a solution. I just installed both front and rear Saner bars and have no issues so far with my ACPT driveshaft rubbing, but my axle nuts are hitting the linkage when I make a medium-hard turn. I tried taking the spacers out and replacing them with washers and that wasn't enough. I also put the bolts the other way with just the nut on the side of the axle and it still hits on one side. Next I plan to go to pick up some new low profile head grade 8 bolts to try. At last resort, I will try to use the stock end links with the Saner bar. Any other ideas?