Quote:
|
Originally Posted by StealthES418
Where can I see the fuel trims? Don't see it in the software anyplace?
Took it out on the street today to do some tuning. Added some fuel since it was running a bit lean..10 across the board. Now the A/F doesn't even display when I let off the gas (not even on my narrowband gauge) and it's now idling between 12.4 and 13.4...I didn't touch the mainscale...only the high throttle AF tune.
Also, it runs lean to around 4500-5000rpms then pegs rich to the low 10's.
So yeah...I'm starting to get fed up with this. Any ideas on what can be wrong? Anyone else running this in AFC mode? Starting to think I should just give up and go with the emanage.
Terry
|
AFC mode is equivalent to the Emanage stuff, so I would think you would have the same issue. It seems that your fuel trims are working against you at the moment. The trims can be seen on a logger.
I would reset the Pro to all zeros in the tune pages, and set the mainscale to 10% rich or so. then reset the ECU and see what you get.
Bob