Quote:
|
Originally Posted by StealthES418
Adjusted the mainscale to +14 and the a/f at idle now cycles between 14.2 or so to 15.2. That normal or is there something that's causing it to jump around like that? The narrowband cycles but it'll cycle a small range then do a full sweep. If I remember correctly the narrowband is somewhat new or is there a chance that's bad and is causing this?
The LM-1 issue was taken care of by changing the analog output settings and changing it to the AEM on the settings.
Sorta off topic here but I figured you guys would know. I have my RPM convertor hooked up to pin 101 for the RPM signal. However it doesn't read correctly after programming it multiple times using the sound card (desktop, not the laptop) and using the engine. Is there a different pin I should use or is there another problem? Not like it's that important anymore since I can log with the tunerpro software but it'd be nice to get it running correctly.
Terry
|
What were your trims doing?