Ouuuuarrrfff!!! Very thank's for this faq!!
all become easy
I received the E-manage Ultimate Air/Fuel input Harness and the Innovate LC-1 Digital Wideband Controller with Sensor.
I have a lquestion about the wire. On the A/F input harness, i have 2 wires (white and gray) and on the LC-A wideband, i have 7 wires (Blue, red, green, black, white, yellow and brown)
here description:
Quote:
|
Originally Posted by innovate LC-1
A. Interface and power cables with 7 stripped ends*:
a. Red 12V supply
b. Blue Heater Ground
c. White System Ground
d. Yellow Analog out 1
e. Brown Analog out 2
f. Green Analog Ground
g. Black Calibration wire
B. Serial In connection, 2.5mm stereo (female) marked as IN
C. Serial Out connection, 2.5 mm stereo (female) marked as OUT.
* 3.1 If you have an LC-1 with only 6 stripped ends (early production) the wiring is as follows:
a. Red 12V supply
b. Blue Heater Ground
c. Metallic System Ground
d. Yellow Analog out 1
e. Brown Analog out 2
f. Black Calibration wire
|
If i understand, i need to connect:
LC-1 Yellow to the white Air/Fuel input Harness
LC-1 Green to the gray Air/Fuel input Harness
Is it correct? Must I connect of another cables from the LC-1?
I always have my aem wideband connected on my race-pipe and i would like to know if i can to keep on the exhaust and add the LC-1 too (of course on the the another o2 Sensor bung) ?
Thank's
Saphir
