but how do I wire up the AEM 3.5 bar map sensor, AEM IAT sensor and the AEM wideband.
AEM wideband, I took my Stillen down pipe off, and had the bung (I don't know if that is the right word for it or not) welded in to my downpipe about 2 inches after it joins to one pipe. I know the plug on the sensor goes to the gauge. Their is another plug that goes to the gauge and it has 4 wires off it. The red wire is power, i think i am going to connect this to the radio power with a 10amp inline fuse, so it comes on when the car is on or in acc mode. next is the black wire which is a ground. next is a white wire 0-5v output, (Analog output) Connects to any auxiliary unit that accepts a 0-5 volt input. i do not know where to connect this wire to. The last wire is a Blue one, which is a Serial Output that connects to a rs-232 com port for hyper-terminal data logging. i do not know where this wire goes as well
Now on to the AEM 3.5 bar map sensor. it only has 3 wires going from it red, green and black.
i think all you have to do, is cut the plug on the stock map sensor and wire the new plug up to it. i think i know where the stock map sensor is. is it right behind the TB and has a plug on it. with the wire colors green with a yellow strip, white with a red strip and a black wire. which wire goes to what on the AEM 3.5 bar map sensor. also where do i put the AEM 3.5 bar map sensor at?
do i just T-off a Vacc line?
Now the AEM IAT. The AEM IAT only has 2 black wires on it. on goes to pin 6 black wire, ground. And the outer one goes to pin 7 red/blue stripe, signal of the stock MAF connector. Do i cut the wire on pin 6 and 7 and connect them to the AEM IAT, or do i just splice into them. does it matter what wire goes to what on the AEM IAT because both of them are black. i am running a stock y-pipe, which i am just going to drill a hole in and put the AEM IAT in it, about 3 inch away from the TB will this work OK?
i know this is a long post, but i did search i got to page 30 and just quit.
but it is also 4:20 in the morning and i need some sleep
