|
I've been here way too long
Join Date: Jul 2004
Location: Southlake, Texas
Drives: 93 VR4 & 95 Spyder
|
Re: AEM Ultimate Resource Thread>>>>
Quote:
|
Originally Posted by lethal_vr4
I debated this for a long time as well. Personally I don't think it will make a diff either way.
With the Alky before the IAT you will "sence" the temp drop the other way around you will not. I was going to put my alky down by the outlet of my FMIC for better atomization so I would not have to worry about the IAT.... however then you vent alky mist through the BOV into the engine bay.
|
The snow kit recomends put it near the throttle body. I think I'm going to mount the IAT a 3-4 inchs before the Water/ Meth nozzle.
IAT----3-4"-----Water/Meth----2-3"--Throttle body
__________________
  R.I.P Spyder you are missed.  Building my dream car...One bolt at a time...Dyno 410.3 Hp and 429.9Tq through stock MAS Balanced, Ported, Polished, Port Matched, Larger valves, 99 lifters, Ross 70 over 8.5 to 1 forged pistons, Stress reliefed shotpeened magnafluxed rods,EK2 Red poly motor mounts, Fidanza Adjustable Cam Gears,Kevlar timing belt, Polished Fuel Rails, Clipped 13G, Gutted Precats, 3SX performance down pipe, Race pipe,QTP Exhaust 3" Cutout, HKS Cat Back, MSD Wires, NGK BCP7ES non-resistor plugs, AEM EMS ECU, Speed Density Conversion, AEM 3.5 MAP, AEM AIT,Dual K&N air filters, Dejon Tool Dual Air Intake, Dejon Tool Y Pipe, PTE 550, Walbro fuel pump, IPO Hot Wire, EK2 fuel loop, No EGR, Vacum line reduction, Greddy Boost Controller, Greddy BOV, AEM Gauge UEGO Controller wideband O2 sensor, Gauge-Tech, Kormex tranny,Quadco XR steel Output shaft, LSE Stainless Steel Transfer Main case and Midcase, Quadco input spool, Lightened flywheel, South Bend 6 Puck DXD F Clutch, Greddy EGT, Autometer Boost Gauge, 3SX fuel pressure gauge, Cross Drilled and Slotted Rotors, Ceramic Brake Pads, 3SX Performance Stainless Steel Braided Brake Lines, Snow Water/Methenol injection system, DSM I/C's , 5Zigen FNO1R-C, Audio: 6 New Infinty speakers. Alpine CDA MP3/WWA 9847 Reciever, 2 Dual 300 watt amps. On the shelf waiting for install: Cianci 3 gauge A pilars, Aluminum defroster vents , 3SX high rev springs with titanium retainers , Plans: AEM 2 step, AEM anti lag, Drag Radials, CFDS, Nitrous progressive setup??? Cianci 1st gen bumper???
WORKING ON CURRENT PROBLEMS: Tuning EMS.
|