Quote:
|
Originally Posted by FastOldGuy
The Snow MAF controller can see a 0-5 volt signal and can adjust flow to increase the alcohol injection the voltage increases from 0-5 volts. Can the AEM output a 0-5 volt based on a manifold presuure signal? In other words can it say: when the manifold pressure is 10psi put a output a voltage of 1 volt then when manifold pressure inceases to 11 psi then send an output voltage of 1.5 volts and keep increasing output voltage as Manifold presure increase all the way up to a maximum of 5 volts.
|
If you are going to do it that way, then why not just use their Variable Controller and hook it up to a boost line?
Or you could use their MAF controller, and tee the MAP sensor signal to that directly also.
I'm not sure that straight boost-based flow is the way to go though. You'd want more water/alky flow at higher rpm than at lower rpm given the same boost level.
You might want to start a new thread about this specific topic, rather than continuing it here.