Re: Make your own valve spring compressor for $15
Quote:
|
Originally Posted by skunkworks
Could you post some pictures (not of your tool) of the valve with the spring so I can see what kind of clearances we are looking at. You could get the "rocker" out with no problem with the cam installed?
thanks
|
Dealers remove rockers all the time with the cam shafts in place to replace lifters. There is a special Mitsu tool but you remove them with screwdrivers if you are careful.
Look at http://www.stealth316.com/misc/insta...ew_lifters.doc for some pics.
Clint
__________________
1991 Stealth RT/TT - Firestorm Red - 193K Miles / Original Owner
Maint: Castrol 10W40 / Mitsu Filter / Rislone
Replaced: 2X clutch / 3X brakes / 2X front rotors / 2X ABS HU / 1X NGK Plugs / 1X Ball joints / 2X Antenna mast / 1X Active exhaust cable / 1X Windshield / 1X Fuel FIlter / 1X Struts / 1X rear rotors / 1X Front Head / VSS / 1X rear wheel bearings / 1X Transfer case (warranty) / 1x Tie rod end (drivers side)
Overhauled: Starter, IAC, BISS, CV Boots
Upgrade: SilverStar Headlights / ebay "Xenon" Fog Bulbs (no more yellow!)
A/F Gauge / MAP - Electronic Boost Logging / MMCd Data Logger
Pending Projects: Steering Rack
|