I have been using the digikey 2.5 bar sensor. I am stock so I don't boost anything over 14-15 on purpose. I have seen spikes to 18 when I had some problems with my mbc. It should go to 21 or so psi no problem.
I would make sure you have mmcd set up to read a 2.5 bar sensor - mmcd defaults to a 3 bar sensor.
sam
Quote:
|
Originally Posted by QuasiMondo
I hate to bring up an old thread like this, but for the folks using the DigiKey chips, how has that chip worked out for you? I installed it for my DSM, and I haven't been able log anything higher than 15.9 psi. I was just wondering if I had hit the limits of my chip, or if it's an issue related to the MMCD software.
|