Quote:
|
Originally Posted by samco
Nice work. I just noticed I was using verison 1.4. Just installed 1.6e and going to give it a try on my lunch hour. Looks like a map sensor is on the "things to order list".
thanks
sam
|
Couple things to try during lunch...
1. When you turn off your car, the Palm will automatically power off within ~10 seconds. Pressing F4 (right hand button) after you start your car will automatically un-pause the unit and start scanning.
2. Try programming O2 alarms for any voltage < .85 V Previously the O2 alarms were useless because the alarm would always go off during closed loop operation. Now the O2 alarms are gated with TPS > 80% so they are disabled during closed loop operation / deceleration.
(I believe Shiver / Chris has implemented this in the most recent version of his SW. Pretty sure PocketLogger does not have this function.)
Clint
__________________
1991 Stealth RT/TT - Firestorm Red - 193K Miles / Original Owner
Maint: Castrol 10W40 / Mitsu Filter / Rislone
Replaced: 2X clutch / 3X brakes / 2X front rotors / 2X ABS HU / 1X NGK Plugs / 1X Ball joints / 2X Antenna mast / 1X Active exhaust cable / 1X Windshield / 1X Fuel FIlter / 1X Struts / 1X rear rotors / 1X Front Head / VSS / 1X rear wheel bearings / 1X Transfer case (warranty) / 1x Tie rod end (drivers side)
Overhauled: Starter, IAC, BISS, CV Boots
Upgrade: SilverStar Headlights / ebay "Xenon" Fog Bulbs (no more yellow!)
A/F Gauge / MAP - Electronic Boost Logging / MMCd Data Logger
Pending Projects: Steering Rack